A home-made gingerbread house seems like a daunting task, but in reality, it's quite easy! Especially with these step-by-step instructions, with photographs to illustrate each step, from making the gingerbread walls and roof and snow, the roof icing to decorating. I've also made all the templates for you. They're full size, so you just print them out and cut them along the lines! Finally, with the openings for the doors and windows, you can even put a small light inside, so your gingerbread house lights up!
It's really quite easy - my 2 1/2 year old helped and had a great time! And if you want to make gingerbread men cookies, see this page - they're even easier!
The keys to success are simple:
If your printer can handle stiff or heavyweight paper, so much the better; use that, but plain paper will do, too. Just print the templates, then cut them out along the heavy solid lines, including the doors and windows. Notice that you really need only one of each roof pieces and the side (since the two long sides and two roof pieces are each identical), and you will reuse them!
The pdf file includes templates for
No, don't run off to you job and try to earn more; we're actually making dough, just like the funny man making the doughnuts. Ok, so you're not old enough to remember that commercial...!
Here's what you'll need:
Now's a good time to get your oven pre-heating to 180 C Gas Mark 4 ( or 350 F)
Melt the butter in the microwave or stovetop until just barely melted.
You might also warm the molasses so it pours and mixes more easily (remember the expression "slow as molasses?). You can heat it in the microwave (with the lid removed) for 45 seconds, or let it sit in a pot of very warm, almost hot, water for 30 minutes.
Pour the melted butter and molasses into your mixing bowl (a large one!)
Now add the eggs, and next the brown sugar! Note how I switched from a whisk to a heavy beater on the mixer.
In another large bowl mix the
If you have a mixer with a dough hook, it is time to put that on. Otherwise, you'll need to (knead to) do this by hand!
Back into the bowl and knead it into a smooth ball.
The dough, that is. No time for you to relax, yet. Put the dough in a ziploc or other container and refrigerate at least 30 minutes. Most directions say that you can even leave it till the next day, and I'm sure you can, but that's not necessary.
Now is a good time to prepare a base to build the house on. I just cut the side of a cardboard box to fit inside a baking pan or cookie sheet with a lip around it. I've heard some people use a piece of plywood, and that's great if you have one lying around...
Then, I covered the cardboard in a sheet of heavy aluminum foil. I put the shiny side down, so it wouldn't be TOO reflective (for photos).
On a silicon baking mat, waxed paper or a floured surface, roll out a small amount of the dough (about the size of a tennis ball) until it is about 1/4 inch thick. Don't get carried away trying to measure it, gingerbread is pretty tough stuff, so it can be as thin as 1/8 in some places or as thick as 1/2 inch, but 1/4 inch (1/2 cm for those of you in other countries) is ideal.
Try to match one one or more of the cut out patterns to the size of the rolled dough. It doesn't need to be an exact fit, you will reuse the trimmings. And don't worry about making the rolled out dough any precise shape (rectangle, circle - just as long as it is bigger than one or more templates, that will do.
Just place one of the paper pattern pieces on the dough and using a dull knife (like a table knife) cut around the edges.
Cut out the windows and doors and just lift out the extra dough. Save the trimming to roll again for the next template.
Now, here is why I like using the silicon baking mats. I can just lift the mats with the dough pieces on it, and lay it on the cookie sheet.
Or lay the cookie sheet over it then turn it over - if you need to reuse the cookie sheet for the next batch.
Here's a tip on windows: you can fill the empty window holes with crushed life-savers to form stained glass windows! It will melt in the oven and fuse to make "glass" panes!
Making the Chimney - The chimney pieces are no different from the others, just smaller! You don't need to make a chimney, but it adds a nice touch. I will admit that they are a pain in the neck to get to stay glued in place until the glue sets. More about that later.
Now pop the tray into the oven and let it cook for 12 to 15 minutes, until it puffs up a little bit and just starts to become golden and slightly firm. While one tray is baling, you can cut out the next patterns.
Then remove the cooked batch and let cool!
Another tip about the cooked dough. It's easy to trim it when it is fresh from the oven, still warm and soft, so you can trim some defects then. But even after it cools completely, it's still pretty easy to trim it with a sharp pair of kitchen shears or a firm, sharp knife that won't bend under pressure. You use a pizza roller or sharp knife to mark lines on the sections just after they are baked, to make shingles and other designs. And you can do it before baking, but they won't be as well defined.
In a large bowl (I like standing electric mixer, like a KitchenAid) beat the egg whites until they begin to foam. Add the cream of tartar and beat until the whites are stiff but not dry.
Gradually beat in the icing sugar, beating for about 5 minutes until it reaches spreading consistency. Keep it covered and refrigerated until needed.
If you have a pastry bag, use that, but it's easy to take a large (1 gallon) ziploc bag. Fill the bag, and pop it into the fridge. When you are ready to use it, just cut off 1/4 inch of a corner and you have an instant pastry bag!
Nah! It's not hard - it only requires ONE thing: time to let the "mortar" dry after you assemble the 4 walls and roof. You can't hurry it. Well, there is one trick I'll show you, but you must let the icing harden befoe you start to deocrate!
Start by laying a bead of icing down along all the seams of the sides, walls and roof. Just like with real glue, it will stick faster and hold better, if we coat the seams where they will connect and let them dry until they are tacky.
Start with a side wall and the end. Stick them together and while one person holds them in place, use your pint or quart jars (filled with contents) to hold them in place. Use whatever you have handy: spaghetti sauce jars, jam, soda cans, as long as it is heavy enough to hold the pieces in place. Add the other end and side, and then the roof pieces.
There's really no trick to it other than:
If the jars and cans are exactly the correct size, use wads of paper towels to build them up. You'll notice I did that to hold the roof pieces in place. The overhangs rest on the cans. I used paper towels to build the cans up so the roof pieces are pushed tight together
The chimney will be a lot easier to attach to the roof if it is already assembled and hardened. Trust me. I tried assembling and gluing it at the same time. It will make a saint curse....
So, having done it the wrong way, I constructed a model of cardboard (see photo at left) to show you the RIGHT way. Using some ordinary adhesive tape, wrap the pieces into the shape shown (the chimney is upside down). Then pour icing down the inside along all four joints.
Let it harden along with the rest (next step)
Now, in a warm, not too humid room, it should be hard enough to work on in about 4 to 6 hours. Overnight is really best.
BUT, if you ARE in a big hurry, here's a trick: aim a hair dryer set on cool and high right at it. Hot won't work, because the icing will melt. But cool will cause it to dry more quickly!
I wait to do the chimney until the walls and roof have hardened in place, preferably overnight.
You will notice I used a large safety pin, pushed gently into the roof, to hold the chimney in place while the icing hardens. Otherwise, the chimney will slowly slide down the roof!
Here's the fun part! Everyone can participate. Give each family member a wall or roof to do!
wild! Icing around the door and windows makes nice trim. To apply candy decorations, dab a small amount of icing to the
underside of the candy and hold in place until set.
You can use dough scraps to roll out added decorative cut-outs to be applied with icing glue. These cutouts can be impressed with designs before baking. For example, you could make window shutters, doors, or figurines! They can be "painted" with colored icing.
I found these little Marshmallow edible figurines at the Wal-Mart. They are exactly the right size to be scaled for the house!
Write me to let me know how your house turned out and any tips you want to share. I hope you and the kids have fun! It should be a memorable experience!
Yep, you can actually spray it with Shellac or lacquer (available from paint stores, Home Depot, Lowes and Wal-Mart) and it should last for years. Just be sure to let it dry completely first. I plan to do my after the holidays, when I am packing things up!
I'll forewarn you that humid environments are a killer for gingerbread houses - they will absorb the moisture and collapse. So it must be kept dry! In a humid area, you would need to seal in an airtight bag.